Datacom Systems VS series Multi-Link Especificações descarregar pdf (Página 12)

Datacom Systems Inc

SPAN and Multi-Link Aggregators/Regenerators • USERguide

SS-200 Application & Hardware Installation —

The SS-200 is used primarily in conjuction with two SS-100s to monitor and anlay-

sis Primary and Redundant Distribution Networks.

Figure 2 depicts a typical set of

monitoring tools attached to a primary circuit that automatically switch to the redundant cir-

cuit allowing uninterrupted monitoring using only one network interface card (NIC) for each

monitoring device to see the combined traffic.

Figure 2 - SS-200 Connectivity Diagram

To connect the SS-200 into the network, refer to FIGURE 3 and follow these steps:

Step 1. Two power supplies are provided for the SINGLEstream

™

SS-100 and one power sup-

ply for the SINGLEstream

™

SS-200. Use of the second power supply is strongly rec-

ommended for the SINGLEstream

™

SS-100 to assure uninterrupted monitoring.

Connect both power supply barrel connectors into the POWER 1 and 2

ports, respec-

tively, of the SINGLEstream

™

SS-100. Plug the power Supplies into the external

power source, furthermore, connecting the second power supply to a different external

power source circuit than the first power supply eliminates power as a single point of

failure. The POWER 1 and 2 LEDs illuminate indicating power 1 and 2, respectively,

are on. Either LED not illuminated indicates a defective power source and immediate

replacement is required to insure redundant power integrity.

IMPORTANT: The maximum length of 100 meters must not be exceeded between end-points.

Step 2. Designate one SINGLEstream

™

SS-100 primary and the other redundant. Connect the

primary network cables to the primary SINGLEstream

™

SS-100 RJ45 port NETWORK A

connector. The NETWORK-A LINK LED illuminates indicating link has been established

between the NETWORK A connector and primary NETWORK A device.

NOTE: Let the “LINK” LED be your guide.

If you are properly connected,

NETWORK-A

and

NET-

WORK-B

“

LINK

”

LEDs

remain illuminated simultaneously.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 43 44

Comentários a estes Manuais

Sem comentários

Datacom Systems VS series Multi-Link Especificações Página 12

Comentários a estes Manuais